Our new rigid system is an addition to the airOlift product line. This system incorporates a special “Heavy Duty Four Point Radial Contact Bearing” top swivel and side linear bearings for extra support. This Rigid manipulator has all of the benefits of a regular airOlift such as light weight and lower cost, but is completely rigid. Could something like this fit your applications?

This unit was designed for quick cycle times. Clamping pads automatically adjust just gripping location so not to damage product. Constructed of aluminum and stainless steel this unit also has a safety system to protect against catastrophic air loss and safety interlocks to prevent the operator from releasing the load while lifting. The unit was designed to lift laser printers and slowly lower into a box. The ergonomic handle/control panel stays within operators ergonomic range and is adjustable for different height personnel.

This unit was designed for high manufacturing cycles, it has suction cups that will automatically actuate depending on the size of the product they are lifting and is constructed of aluminum. The unit also has a dual pump safety system to protect against catastrophic air loss and safety interlocks to prevent the operator from releasing the load while lifting. The unit was designed to lift the TV’s and slowly lower into a box. The ergonomic handle/control panel is extended, vertical and adjustable.

This unit was designed for a national manufacturer of computer equipment. The unit has a 60 lb. lift capacity and 35″ of vertical lift available. The attachment incorporates a 90° upender, a low profile rotary joint, (2.25″) and a 360° swivel at the cup. The sequence of operation is to pick the computer from a conveyor, rotate for inspection, place Styrofoam inserts on each end, “downend” and place into box. Could an application like this solve your problem?

The Problem: A Mid-western company needed to extract cheese from a box.

The Solution: An AiroLift with cheese/box extractor attachment manufactured by Conec

The Result: a 25%+ increase in production

The unit will provide suction, with dual Venturi pumps and (2) large, rectangular, (FDA approved), cups, lift then pneumatically extract the cheese with dual pistons. The unit shown has 250 lbs. capacity and 59″ of vertical lift. All components are constructed of 304/316L stainless steel including the protective enclosure. “Dairy” switches are used for protection during wash-down procedures. The operator can’t release when the cheese is in the air and in the event of a catastrophic air loss the cheese can’t be extracted from the box. A self-leveling handle is also included

This unit was designed to pneumatically clamp cheese in a fiber barrel, lift and rotate 180°. The maximum capacity is 750 lbs with a 40″ vertical lift. This unit is constructed of stainless steel including the bellows cover and top swivel assembly. The operator has total control in the high and/or low stacking mode due to dual controls. Increase productivity by suspending this AiroLift from a single girder, enclosed track system. Could something like this fit your applications?

The unit has a 250lb maximum capacity and 35″ vertical lift available. The attachment incorporates a 90°; upender, a low profile rotary joint, (2.25″) and a 360° swivel at the cup. The sequence of operation is to pick the panel off a pallet, upend and place into position. Could something like this fit your applications?